Notes on Raspberry Pi and Serial

I experimented with my Raspberry Pi (v1 B) and a serial cable, a USB-serial identified as:

[85907.504415] usb 4-5: new full-speed USB device number 19 using ohci-pci
[85907.730850] usb 4-5: New USB device found, idVendor=0403, idProduct=6001
[85907.730863] usb 4-5: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[85907.730871] usb 4-5: Product: TTL232R-3V3
[85907.730877] usb 4-5: Manufacturer: FTDI
[85907.730882] usb 4-5: SerialNumber: ********
[85907.737978] ftdi_sio 4-5:1.0: FTDI USB Serial Device converter detected
[85907.738070] usb 4-5: Detected FT232RL
[85907.744057] usb 4-5: FTDI USB Serial Device converter now attached to ttyUSB1

My USB-serial-device has six cables: black-brown-red-orange-yellow-green.
Connected to the RPi from the corner pin: none-none-black-yellow-orange-none8x.

At this point I have no success with minicom. Screen works though:

sudo minicom -b 115200 -o -D /dev/ttyUSB1
sudo screen /dev/ttyUSB1 115200

When serial works, my procedure is:

  1. Connect everything except power
  2. Start screen
  3. Connect power
  4. Within a few seconds i get output

If I start a fresh default NOOBS (v1.4):

Uncompressing Linux... done, booting the kernel.

Welcome to the rescue system
recovery login: 

You can log in with root/raspberry, but I don’t know if you are meant to (can) install Raspbian this way.

NOTE: The Raspberry Pi itself prints nothing to the serial console. Only with a properly installed SD-card inserted, you get output.

Already installed System
For an already installed Raspbian, I got a normal login prompt over serial.
For an already installed OpenWRT (14.07), I got a root prompt, no password required, over serial.

Formatting SD-card using Linux
Sometimes it is hard to produce an SD-card that the Raspberry Pi wants to boot from.
This partitioning and formatting works:

$ sudo /sbin/fdisk -l /dev/sde

Disk /dev/sde: 7,4 GiB, 7948206080 bytes, 15523840 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disklabel type: dos
Disk identifier: 0x00055f28

Device     Boot Start      End  Sectors  Size Id Type
/dev/sde1        2048 15523839 15521792  7,4G  e W95 FAT16 (LBA)

gt@oden:~/Downloads$ sudo mkfs.vfat /dev/sde1
mkfs.fat 3.0.27 (2014-11-12)

To be on the safe side, before using fdisk:

$ sudo dd if=/dev/zero of=/dev/sde bs=1024 count=10240

Leave a Comment


NOTE - You can use these HTML tags and attributes:
<a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>

Time limit is exhausted. Please reload CAPTCHA.

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Trackbacks and Pingbacks: